VIP DOUBLE SIDED SLIDE HAMMER AND METAL HEADS SET - SILVER, BLACK AND GRAY
- Anodized Aluminum ends, stainless weight and carbon fiber sliding shaft
- 2 side threaded for cold glue tabs with 5/16" thread
- Pulling tabs adapter allow to have cold glue and hot glue setup
- Stainless steel slide weighs 1 pound 10oz or 750g with rubber bumpers on the both sides
- Total weight 3lb 8oz or 1.6 kg
- Great for aluminum and steel panels
- VIP METAL HEADS - cold glue tip set with magnetic storage case
- Made of high grade stainless steel
- Set of 5
- Small - 0.5" or 13mm in diameter
- Medium - 0.6" or 16mm in diameter
- Large - Quarter size 1" (24mm)
- Extra large - Half Dollar size 1.2" (29mm)
- Rectangle - Crease tab - 1.6" x 0.45" or 40 x 12mm
- Need to prep before using
- Always keep them clean
- Adhesion promoter pouch and preparation instructions are included
-
COLD GLUE NOT INCLUDED*
PREPARATION INSTRUCTIONS:
- Prepare all 5 tips at the same time
- Clean the mushroom of the tip with alcohol (top, bottom, and sides)
- Blow the moisture with propane torch or heat gun
- Open pouch included in the set
- Wait a few minutes until the adhesion promoter evaporates
- Wash hands, then stick cold glue of your choice and firmly formate around the mushroom tip
YouTube: VIP METAL HEADS PREPARATIONS
https://www.youtube.com/watch?v=m5cSTsnw78Q&t=132s
GOOD LUCK $$$
Designed by VIP INC.
Safety Disclaimer:
Always wear appropriate personal protective equipment (PPE), including safety glasses, when using PDR tools. Failure to do so may result in injury. VIP PDR Tools is not responsible for injuries caused by misuse or lack of safety precautions.